Product Details

Note: Use the machine for 10 seconds, then pause for 5 seconds before resuming.
Ensure the machine is locked (refer to the diagram on the reverse side under “To Replace Batteries”). Raise the needle arm to its highest position using the rotary wheel.
The rotary wheel can be turned in either direction (see diagram #1).
Lift the fastening plate without pressing down on the needle arm. Place fabric beneath the fastening plate (refer to diagram #2).
Pull approximately 2 inches of thread through the needle from back to front before starting to sew.
Hold the Handy Stitch with your right hand and use your thumb to operate the power switch, with other fingers supporting the base (see diagram #3).
Unlock the machine (see diagram on reverse side under “To replace Batteries”). Press the power switch with your right thumb. The machine will automatically feed the cloth with proper tension. Use your left hand to hold the cloth and guide its direction. Maintain steady motion for wider stitches by pulling the cloth to the left a little faster. Follow the centerline on the fastening plate for straight stitching (refer to diagram #4).
When finishing a seam, position the needle arm to its highest point by turning the rotary wheel. Use the back of a seam ripper or scissors to pull the thread out about 3 inches before cutting it (see diagrams #5 and #6).
Turn the rotary wheel, lowering the needle into the fabric. Continue turning until the needle arm is at its highest position again.
Lift the fastening plate and carefully remove the cloth, ensuring not to pull the thread to avoid unraveling.
To create a knot on the back side of the cloth, guide the reserved 3 inches of thread:

Pass the threader through the last stitch.
Insert the thread into the threader.
Pull out about 1 inch.
Guide the thread through the loop and tighten to finish the knot.

Note: Ensure the thread flows from the top right of the bobbin or spool. The spring must be in place before installing the bobbin.

Threading Instructions

Thread the Handy Stitch as shown in diagrams 7, 8, and 9.
Pass the thread through the eyelet on the needle arm (refer to diagram #7).
Pass the thread over the top of the tension control without wrapping it completely around (see diagram #8).
Use a threader to pass the thread through the needle eye from back to front (see diagram #9).

Tension Adjustment

If stitching is too tight, adjust the tension control slightly to the left.
If too loose, adjust it slightly to the right.

Installing a Normal Thread Spool

Loosen the bobbin nut and remove the bobbin.
Slide the thread spool onto the extension spindle.
Connect the extension spindle to the bobbin shaft.
Loosen the set screw with a screwdriver and replace the old needle with a #14 style DHx1 needle, ensuring the flat side of the shank faces the front (see diagram #11).

Battery Replacement

Ensure the machine is locked before replacing batteries (refer to diagrams below).
CAUTION: Needles are sharp; handle with care and keep out of reach of children. Always store the machine in a locked position when not in use.

Product Overview

The Mini Portable Handy Sewing Machine is essential for various sewing tasks. Its sturdy design allows it to handle different fabric types, making it suitable for kids' clothing, home decoration, and travel needs. This lightweight, battery-operated tool is user-friendly and efficient, achieving sewing speeds of 500-1000 stitches per minute, perfect for all levels of sewing expertise.

Emporium Elite Mini Portable Handheld Sewing Machine - Battery-Powered Tool for Sewing Fabrics, Clothing & Travel Use | White Color