Description
0-3---1-3-"5--9__3""0--0--6""7
نیو باکس پیک ہے اپنے پتہ پہ منگوا کر اچھی طرح چیک کرنے کے بعد قیمت ادا کریں واٹس ++ایپ پر رابطہ کریں {03,13,59,300,67(
IN OPERATION LED INDICATOR POWER ON LEG INDICATOR
AC CONNECTOR
IEC (View phone number)
FM18 2 WIRE
FM2S 3 WIRE
TECHNICAL SPECIFICATION
STANDARD
NOMINAL VOLTAGE
FM1S2 WIRE FM2S 3 WIRE:
RATED CURRENT
MINIMUM CURRENT
FREQUENCY
POWER CONSUMPTION
ACCURACY CLASS
DISPLAY
INTERFACE
IMPULSE imp/kWh
YELLOW LED
RED LED
OPERATING TEMPERATURE
RELATIVE HUMIDITY
WEIGHT
EC (View phone number)
110,(View phone number)V±10% 110/220V 120/240V±10%
<85%
ABOUT 0.3Kg
5 (60) A. 30(100)A. 20(100)A 5(100) A. 10(100)A,
0.04A
50 or 60Hz
2W/10VA
1
Analogue 5+1 LCD6+1 or 5+2 OPEN COLLECTOR OUTPUT(SO)
SEE METER
POWER ON
IMPULSE
(View phone number)
3. Under dusting circumstance or where the meter may destroyed, the meter must be installed in the protection cabinet.
INSTALLATION AND USE
When power line input the L1 and L2/N, down to penetrate the insulating layer of the power lines
1. Once the meter is examined as "qualified" and sealed, it can be installed. If there is no seal or deposit so long, it must be constant by relative department again, and then be installed so as to assure the measurement accuracy.
2. The meter should be installed indoor and airiness, the bottom plate which the meter fixed in should be placed in the solid, fire proof wall. It is suggested that the height of the installation should be above 1.8m and keep the meter upright.
4. The meter should be correctly connected with the circuit according with stipulated sequence(positive phase sequence), and according to wiring diagram. Moreover, it must use copper wire and connector so as to avoid burning owing to the poor contact of the copper connector in the terminal box.
DIMENSION DIAM
36.5
Class1
SINGLE PHASE ENERGY METER
USER MANUAL
44
75
68
73
WARRANTY
Warranty is vold if seal is removed/damaged.
CAUTION
Directly Sun lighting should be avoided,
The meter should be keep in its primary package, the temperature of the stocking place should be-30°C~+70°C, the relative humidity should not exceed 85%, and the air contains no corrosive gas;
Ver(View phone number)